Tools and Utilities
7-3
Using the MIC BIOS Setup Utility
If your system does not have a monitor attached to the CE, prior to running the MIC BIOS utility
to perform tests, you must either attach a monitor to the CE or use a video/keyboard/mouse
switch if you installed one.
Before using the MIC BIOS utility for testing, you must choose and properly configure all
elements you will be examining and testing. You also use the MIC BIOS Setup utility to
configure the MIC.
The BIOS Setup utility starts by either of the following means:
•
During MIC initialization, after the banner has been displayed and before initialization is
complete, type
Control-M
or press the
Enter
key to launch the utility.
•
The system automatically enters the setup utility if the MIC identity has not been assigned
previously.
When the BIOS setup utility launches, if the MIC identity is unknown, the screen shown in
Figure 7-1
displays. Before proceeding, you must specify the appropriate identity (CE1, CE2,
IOP1, or IOP2) corresponding to its role in the system in which it is installed.
Figure 7-1 MIC Setup Screen with MIC Identity Unknown
Summary of Contents for NetServer AA 6200
