Endurance Server Maintenance
9-3
Rebooting an IOP
Before you reboot an IOP, consider the following points which may affect your decision to
reboot the IOP at that time.
•
When an IOP is removed from service (powered off, disabled, faulted or booted in any
mode other than
Operational Endurance I/O Processor Mode
):
-
Any non-mirrored devices that physically reside on that IOP are not available to the
Endurance server.
-
If the CE operating system will be restarted while the IOP is removed from service,
you must once again reboot the CE after the IOP is again online in order for non-
mirrored devices connected to the IOP to come online.
-
The keyboard and mouse attached to that IOP are not available to the CE operating
system.
-
Redirected video from the CE operating system is not available.
•
As an alternative to removing an IOP from service, consider scheduling an appropriate
maintenance time (the same day) when you can remove the Endurance server from
service. Then, use the procedure
Rebooting the Endurance Server
to avoid remirroring all
mirrored disk sets.
Summary of Contents for NetServer AA 6200
