9-14
HP Netserver AA Solution Administrator’s Guide
Replacing an IOP
x
.Ethernet Fiber or Cable
The IOP
x
.Ethernet fiber or cable connects the IOP to the public Ethernet.
Caution:
Before proceeding, make sure you are properly grounded using,
for instance, a wrist strap with an attached alligator clip that is
connected to an appropriate ground.
To replace an IOP
x
.Ethernet fiber or cable:
Step
Action
Notes
1
Obtain a replacement Ethernet cable
from your service provider that meets
the specifications for your network.
Obtain the appropriate fiber or cable that meets
the specifications for your Ethernet adapter.
2
Using Endurance Manager, make sure
that the other IOP is active and that it
has public network connectivity.
The IOP
y
.Ethernet is
online
or on
standby
.
3
Remove the IOP
x
.Ethernet cable by
detaching it from the IOP and the public
Ethernet network.
4
Install the new Ethernet cable by
attaching it to the IOP and the public
Ethernet network.
5
Make sure that the Ethernet connection
that uses the replacement cable is on
standby
(appears dark green).
Use Endurance Manager for this step.
Summary of Contents for NetServer AA 6200
