Chapter 4
Accessories
17
4. Read the documentation included with the accessory for any special
handling or installation instructions.
WARNING
Before removing the cover, always disconnect the power cord
and unplug telephone cables. Disconnect the power cord to
avoid exposure to high energy levels that may cause burns
when parts are short-circuited by metal objects such as tools
or jewelry. Disconnect telephone cables to avoid exposure to
shock hazard from telephone ringing voltages.
5. Remove the NetServer cover.
CAUTION
Wear a wrist strap and use a static-dissipating work surface
connected to the chassis when handling components.
6. Remove the mass storage tray from one of the empty front shelves. Save
the screws for reuse.
7. If the CD-ROM is not an HP accessory, attach the mounting rails to the
CD-ROM with the screws provided.
8. Slide the drive completely into the shelf.
9. Connect the power and data cables to the rear of the drive (the connectors
are shaped to go in one way only). See “IDE Cabling” for more
information about which connectors to use.
10. Secure the drive in position using the screws removed from the mass
storage tray in step 6.
11. To allow access to the drive, remove the corresponding shelf filler panel
from inside the front bezel.
12. Replace the cover, external cables, and power cords.
Installing an IDE Hard Disk Drive In a Front Shelf
NOTE
If your new hard disk drive already has a mounting tray
attached, you must remove it before you can install the drive
in your NetServer.
Summary of Contents for NetServer E 45
