Chapter 5
Troubleshooting
25
If it is a hardware error, follow these steps:
1. Log users off the LAN and power down the server. Remove the NetServer
cover.
WARNING
Before removing the cover, always unplug telephone cables
and disconnect the power cord. Unplug telephone cables to
avoid exposure to shock hazard from telephone ringing
voltages. Disconnect the power cord to avoid exposure to high
energy levels that may cause burns when parts are short-
circuited by metal objects such as tools or jewelry.
2. Simplify the HP NetServer configuration to the minimum required: a
monitor, one flexible disk drive, one CD-ROM drive, one hard disk drive,
keyboard, mouse, and NIC. Remove all third-party options, and reinstall
one at a time, checking the system after each installation.
3. Boot the system. If the system does not function, refer to the following
procedures. If you get an error message, see the section “Error Messages,”
below.
4. If the system still will not boot, clear the CMOS memory and reboot (see
"Clearing the CMOS Configuration,").
Error Messages
If you get a POST error message, press Enter (View System Error) to get a more
detailed explanation and a possible solution.
No Error Messages Displayed
General Checks
1. All external cables and power cables are firmly plugged in.
2. The power outlet is working.
3. The computer and display are turned on. (The power-on indicator should
be illuminated).
4. The display’s contrast and brightness settings are correct.
5. All internal cables are properly connected and all boards firmly seated.
Summary of Contents for NetServer E 45
