Chapter 1
Installation Overview
2
Remove the Cover
If you are installing options, you will need to remove the cover. To install
options, you will need a flat 1/4-inch screwdriver and T15 TORX® driver; you
do not need tools to remove the cover.
WARNING
Before removing the cover, always disconnect the power cord
and unplug telephone cables. Disconnect the power cord to
avoid exposure to high energy levels that may cause burns
when parts are short-circuited by metal objects such as tools
or jewelry. Disconnect telephone cables to avoid exposure to
shock hazard from telephone ringing voltages.
To remove the cover:
1. Turn off the NetServer and disconnect the power cord.
2. Unlock the cover: To unlock the cover, use the key in the key bag located
on the rear of the NetServer.
3. Release the latches: Lift up the two release latches on the sides of the front
bezel.
4. Remove the NetServer cover. Place your hands on the top of the cover,
one along each edge (see Figure 1-1). While applying downward pressure,
pull the cover sharply forward to release it and then slide it forward and
off the NetServer.
5. Remove the cooling duct/cover.
◊
Unplug the fan cable from the power supply harness.
◊
Lift up on the front of the duct/cover until the hook is free of the slot,
as shown in Figure 1-2.
◊
Gently pull the duct/cover toward the front of the NetServer and lift it
up and out of the chassis.
Summary of Contents for NetServer E 45
