HP P2000 G3 MSA System CLI Reference Guide 133
set advanced-settings
Description
Sets advanced system configuration options.
Syntax
set advanced-settings
[auto-write-back enabled|disabled|on|off]
[background-disk-scrub enabled|disabled|on|off]
[background-scrub enabled|disabled|on|off]
[background-scrub-interval
interval
]
[compact-flash-failure enabled|disabled|on|off]
[controller-failure enabled|disabled|on|off]
[dynamic-spares enabled|disabled|on|off]
[emp-poll-rate
rate
]
[fan-failure enabled|disabled|on|off]
[host-cache-control enabled|disabled|on|off]
[independent-cache enabled|disabled|on|off]
[managed-logs enabled|disabled|on|off]
[missing-lun-response notready|illegal]
[partner-firmware-upgrade enabled|disabled|on|off]
[partner-notify enabled|disabled|on|off]
[power-supply-failure enabled|disabled|on|off]
[smart enabled|disabled|on|off|detect-only]
[super-cap-failure enabled|disabled|on|off]
[sync-cache-mode immediate|flush]
[temperature-exceeded enabled|disabled|on|off]
[utility-priority low|medium|high]
[spin-down enabled|disabled|on|off]
[spin-down-delay
delay
]
[single-controller]
Parameters
auto-write-back enabled|disabled|on|off
Optional. Sets whether the cache mode will change from write-through to write-back when the
trigger condition is cleared.
•
disabled
or
off
: Auto-write-back is disabled.
•
enabled
or
on
: Auto-write-back is enabled. This is the default.
background-disk-scrub enabled|disabled|on|off
Optional. Sets whether disks that are not in vdisks are automatically checked for disk defects to
ensure system health. Background disk scrub will start 72 hours after it is enabled. The interval
between background disk scrub finishing and starting again is 72 hours.
•
disabled
or
off
: Background disk scrub is disabled. This is the default.
•
enabled
or
on
: Background disk scrub is enabled.
background-scrub enabled|disabled|on|off
Optional. Sets whether disks in vdisks are automatically checked for disk defects to ensure system
health. The interval between background vdisk scrub finishing and starting again is specified by the
background-scrub-interval
parameter.
•
disabled
or
off
: Background vdisk scrub is disabled.
•
enabled
or
on
: Background vdisk scrub is enabled. This is the default.
background-scrub-interval
interval
Optional. Sets the interval in hours between background vdisk scrub finishing and starting again,
from 1–360 hours. The default is 24 hours.
Summary of Contents for P2000 G3
