HP P2000 G3 MSA System CLI Reference Guide 211
show debug-log-parameters
Description For use by or with direction from a service technician.
Shows which debug message types are enabled (
On
) or disabled (
Off
) for inclusion in the Storage
Controller debug log.
Syntax
show debug-log-parameters
Output
•
host
: Host interface debug messages. Enabled by default.
•
disk
: Disk interface debug messages. Enabled by default.
•
mem
: Internal memory debug messages. Disabled by default.
•
fo
: Failover and recovery debug messages. Enabled by default.
•
msg
: Inter-controller message debug messages. Enabled by default.
•
ioa
: I/O interface driver debug messages (standard). Enabled by default.
•
iob
: I/O interface driver debug messages (resource counts). Disabled by default.
•
ioc
: I/O interface driver debug messages (upper layer, verbose). Disabled by default.
•
iod
: I/O interface driver debug messages (lower layer, verbose). Disabled by default.
•
misc
: Internal debug messages. Enabled by default.
•
rcm
: Removable-component manager debug messages. Disabled by default.
•
raid
: RAID debug messages. Enabled by default.
•
cache
: Cache debug messages. Enabled by default.
•
emp
: Enclosure Management Processor debug messages. Enabled by default.
•
capi
: Internal Configuration API debug messages. Enabled by default.
•
mui
: Internal service interface debug messages. Enabled by default.
•
bkcfg
: Internal configuration debug messages. Enabled by default.
•
awt
: Auto-write-through cache triggers debug messages. Disabled by default.
•
res2
: Internal debug messages. Disabled by default.
•
capi2
: Internal Configuration API tracing debug messages. Disabled by default.
•
dms
: Snapshot feature debug messages. Enabled by default.
•
fruid
: FRU ID debug messages. Enabled by default.
•
resmgr
: Reservation Manager debug messages. Disabled by default.
•
init
: Not used.
•
ps
: Not used.
•
hb
: Not used.
Example
Show debug log parameters:
# show debug-log-parameters
Debug Log Parameters
--------------------
host: On
disk: On
mem: Off
...
Success: Command completed successfully. (2012-01-18 14:59:52)
Basetypes
•
debug-log-parameters
•
status
See also
•
set debug-log-parameters
Summary of Contents for P2000 G3
