10.
Plug the cache into the connector on the controller, routing the battery cable so that the cache
and battery can be removed together if necessary.
NOTE:
Keep the battery connected to the cache so that the data is preserved.
11.
Reinstall the access panel.
12.
Reinstall the server blade in the blade enclosure.
After reinstalling the server blade, reset the BIOS. For instructions, see
13.
Verify component status.
14.
Confirm that both server blades are running the same firmware version.
NOTE:
Use the CMC Hardware Report to view the controller firmware version.
If the server blades are not running the same firmware version, update the controller firmware
with the Smart Update Firmware DVD located at
.
For detailed instructions, see “Installing a mezzanine controller in a previously configured server
blade” in the HP Smart Array Controllers for HP ProLiant Servers User Guide.
For instructions on replacing the battery and cache, see “Upgrading or replacing controller options”
in the HP Smart Array Controllers for HP ProLiant Servers User Guide.
Replacing the VC Flex-10 module
CAUTION:
Be sure to update the firmware on the new VC Flex-10 module. This operation will
take the volumes offline.
IMPORTANT:
Clients will lose connectivity during this procedure unless using a bonded network.
If not using a bonded network, clients should be disconnected before starting the procedure. In
addition, both externally facing uplinks must be connected to your external network. If uplinks are
not connected to the external network, connectivity will be lost when one of the Flex-10 switches
goes offline during a firmware update.
To replace a VC Flex-10 module:
1.
Disconnect the network connections into the VC Flex-10 module (bay 1 or 2).
2.
Remove the VC Flex-10 module.
3.
Replace the VC Flex-10 module.
4.
Reconnect the cables that were disconnected in Step 1 to their original ports.
5.
Restore the configuration settings.
For more information, see
“Backing up HP P4800 G2 solution configurations” (page 11)
Replacing the SAS switch
This section provides instructions for removing and replacing the SAS switch in the HP P4800 G2
solution.
CAUTION:
Before replacing the SAS switch, be sure to power down the server blades using the
procedures to shut down the management group in the CMC Online Help or HP P4000 SAN
Solution User Guide.
24
Removing and replacing the HP P4800 G2 solution components
Summary of Contents for P4800 G2
Page 4: ...Battery replacement notices 46 Glossary 50 Index 51 4 Contents ...
Page 47: ...French battery notice German battery notice Battery replacement notices 47 ...
Page 48: ...Italian battery notice Japanese battery notice 48 Regulatory compliance notices ...
Page 49: ...Spanish battery notice Battery replacement notices 49 ...
