Installing components
Installing components in a rack
The following steps outline the sequence for installing rack-mountable components in a rack.
IMPORTANT:
These installation instructions are for standard installations. For specific installation instructions, refer to
the documentation included with the component.
Hewlett Packard Enterprise strongly recommends installing a stabilizer foot before any other component.
Install 0U devices first, such as PDUs, console switches, and so on.
Procedure
1.
Install the cage nuts into the rack (if required).
2.
Prepare and install the rails into the rack.
3.
Prepare and install the component into the rack and secure it.
4.
Attach the cable management arm to the rack and then to the component.
5.
Attach any cables and power cords. Be sure to adhere to all cautions and warnings contained in the
individual component installation instructions.
6.
Remove the cable access panel and route the cables.
Installing the cage nuts
Use the cage nut insertion tool to install the cage nuts on the inside of the mounting rails.
Procedure
1.
Hook the bottom lip of the cage nut in the square-rail perforation.
2.
Insert the tip of the insertion tool through the perforation and hook the top lip of the cage nut.
3.
Use the insertion tool to pull the cage nut through the hole until the top lip snaps into position.
Installing components
13
Summary of Contents for P9K37A
Page 4: ...Warranty information 25 4 Contents ...
Page 15: ...Installing components 15 ...