f.
Display assembly (see
Display assembly on page 73
)
g.
Top cover (see
Top cover on page 82
)
Remove the USB board:
1.
Disconnect the USB board cable
(1)
from the system board.
2.
Remove the Phillips PM2.5×4.0 screw
(2)
that secures the USB board to the base enclosure.
3.
Remove the USB board
(3)
from the base enclosure.
Reverse this procedure to install the USB board.
Fan
Description
Spare part number
For use only with computer models equipped with AMD processors
488885-001
For use only with computer models equipped with Intel processors
480481-001
NOTE:
To properly ventilate the computer, allow at least a 7.6-cm (3-inch) clearance on the right side
and rear panel of the computer. The computer uses an electric fan for ventilation. The fan is controlled
by a temperature sensor and is designed to turn on automatically when high temperature conditions
exist. These conditions are affected by high external temperatures, system power consumption, power
management/battery conservation configurations, battery fast charging, and software applications.
Exhaust air is displaced through the ventilation grill located on the left side of the computer.
Before removing the fan, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4.
Remove the battery (see
Battery on page 51
).
5.
Remove the following components:
a.
Hard drive (see
Hard drive on page 56
)
b.
Optical drive (see
Optical drive on page 54
)
96
Chapter 4 Removal and replacement procedures
Summary of Contents for Pavilion dv7-1100 - Entertainment Notebook PC
