Switch cover
NOTE:
The switch cover includes the power button board and cable and LED board and cable.
Description
Spare part number
For use only with computer models equipped with AMD processors
480469-001
For use only with computer models equipped with Intel processors
485605-001
Before removing the switch cover, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 51
).
Remove the switch cover:
1.
Remove the following screws:
(1)
Seven Phillips PM2.5×4.0 screws
(2)
One Phillips PM2.5×13.0 screw
2.
Turn the computer display-side up, with the front toward you.
3.
Open the computer as far as possible.
4.
Lift the rear edge of the switch cover
(1)
until it rests at an angle.
66
Chapter 4 Removal and replacement procedures
Summary of Contents for Pavilion dv7-1100 - Entertainment Notebook PC
