Before removing the TouchPad LED board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 40
).
5.
Remove the service door (see
Service door on page 41
).
6.
Remove the optical drive (see
Optical drive on page 42
).
7.
Remove the hard drive (see
Hard drive on page 44
).
8.
Remove the keyboard (see
Keyboard on page 51
).
9.
Remove the top cover (see
Top cover on page 56
).
10.
Remove the TouchPad button board (see
TouchPad button board on page 63
).
Remove the TouchPad LED board and cable:
1.
Turn the top cover upside down, with the front toward you.
2.
Apply slight pressure to the retention clips
(1)
of the top cover.
3.
Lift the TouchPad LED board on the right front corner
(2)
up and away from the top cover.
4.
Remove the TouchPad LED board and cable.
Reverse this procedure to install the TouchPad LED board and cable.
ENWW
Component replacement procedures
65
Summary of Contents for Pavilion g6-2200
