v
FCC Statement
CANADIAN NOTICE:
This Class B digital apparatus complies with
Canadian ICES-003.
Regulatory and Safety
Information
WARNING:
The TV is heavy; be sure to use
ergonomically correct lifting procedures when
moving the TV.
Additional safety information
This product has not been evaluated for connection
to an “IT” power system (an AC distribution system
with no direct connection to earth, according to
IEC 60950).
AC Power Safety Warning
WARNING:
Install the TV near an AC outlet. The AC
power cord is your main AC disconnecting device and
must be easily accessible at all times. For your safety, the
power cord provided with your TV has a grounded plug.
Always use the power cord with a properly grounded
wall outlet, to avoid the risk of electrical shock.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
■
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and receiver.
■
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
■
Consult HP or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
FCC Caution:
To assure continued compliance and reduce possible undesirable interference, the provided ferrite cores
must be used when connecting this plasma television to video equipment; maintain at least 40 cm
spacing to other peripheral devices. Refer to instructions:
■
“Attaching the ferrite core” on page 8.
■
“Connecting a PC” on page 17.
■
“TV Front Panel” on page 19.
Any changes or modifications not expressly approved by responsible party may cause harmful
interference and could void the user’s authority to operate this device.
RESPONSIBLE PARTY:
Hewlett-Packard Company
Digital TV Solutions
Attn: Product Regulations Manager
10435 N. Tantau Avenue
CAC 07, MS 4295
Cupertino, CA 95014
USA
mb5pohtv.book Page v Wednesday, July 6, 2005 9:52 AM
