POGO pin connector
Description
Spare part number
POGO pin connector and cable
823960-001
1.
Turn off the tablet. If you are unsure whether the tablet is off, turn the tablet on, and then shut it down
through the operating system.
2.
Disconnect the power from the tablet by unplugging the power adapter cord from the tablet.
3.
Disconnect all external devices from the tablet.
4.
Remove the MicroSD card tray (see
MicroSD card tray on page 17
).
5.
Remove the Nano SIM card tray (select products only) (see
Nano SIM card tray (select models only)
on page 18
.
6.
Remove the back cover (see
Back cover on page 18
).
7.
Disconnect the battery (see
Disconnecting the battery on page 19
).
8.
Remove the WWAN module (see
WWAN module (select models only) on page 21
).
9.
Remove the left speaker (see
Left speaker on page 23
).
10.
Remove the audio board (see
Audio board on page 24
).
11.
Remove the vibration motor board (see
Vibration motor board on page 26
).
12.
Remove the front-facing webcamera (see
Front-facing webcamera on page 27
).
13.
Remove the rear-facing webcamera (see
Rear-facing webcamera on page 28
).
14.
Remove the system board (see
System board on page 30
).
15.
Remove the right speaker (see
Right speaker on page 35
).
16.
Remove the battery and middle plate (see
Battery and middle plate on page 36
).
17.
Remove the outer ring (see
Outer ring on page 38
).
Remove the POGO pin connector:
1.
Remove two 2.3 mm P0 Phillips screws (1), that secure the POGO pin connector to the display enclosure
(1).
40
Chapter 5 Removal and replacement procedures
Summary of Contents for Pro Tablet 608 G1
Page 4: ...iv Safety warning notice ...