RJ-11 jack cable
NOTE:
The RJ-11 jack cable is included in the Cable Kit, spare part number 646369-001.
Before removing the RJ-11 jack cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
).
b.
c.
Optical drive (see
)
d.
WLAN module (see
WLAN/Bluetooth combo card on page 59
e.
WWAN module (see
)
f.
)
g.
Fan (see
)
h.
Heat sink (see
i.
Keyboard (see
j.
Top cover (see
Remove the RJ-11 jack cable:
1.
Position the computer right-side up with the front toward you.
2.
Remove the tape
(1)
that secures the cable to the computer.
3.
Remove the RJ-11 jack cable from the clips and routing channel
(2)
built into the base enclosure.
Component replacement procedures
87
Summary of Contents for ProBook 4330s
Page 4: ...iv Safety warning notice ...
Page 8: ...viii ...
Page 30: ...Computer major components 22 Chapter 3 Illustrated parts catalog ...
Page 153: ......
