RJ-11 jack cable
NOTE:
The RJ-11 jack cable is included in the Cable Kit, spare part number 646303-001.
Before removing the RJ-11 jack cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 41
).
5.
Remove the following components:
a.
Bottom door (see
Bottom door on page 43
).
b.
Optical drive (see
Optical drive on page 44
)
c.
Modem module (see
Modem module on page 70
)
d.
Keyboard (see
Keyboard on page 57
)
e.
Top cover (see
Top cover on page 59
)
f.
USB board (see
USB board on page 73
)
Remove the RJ-11 jack cable:
1.
Position the computer upright with the front toward you.
2.
Remove the tape
(1)
that secures the cable to the computer.
3.
Remove the RJ-11 jack cable from the clips and routing channel
(2)
built into the base
enclosure.
Component replacement procedures
75
