4.
Grasp the Mylar cover on the hard drive and slide the hard drive to the left
(2)
to disconnect it
from the system board connector and lift it from the hard drive bay. .
5.
If it is necessary to replace the hard drive bracket, unwrap the mylar cover
(1)
that surrounds the
drive.
6.
Remove the two Phillips PM3.0×3.0 hard drive bracket screws
(2)
from each side of the hard
drive (4 total screws).
7.
Lift the mounting bracket from around the hard drive
(3)
.
46
Chapter 4 Removal and replacement procedures
