Battery cable
The battery cable is included in the Cable Kit, spare part number 723646-001.
Before removing the battery cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Service door (see
).
b.
Hard drive (see
)
c.
Optical drive (see
d.
WLAN/Bluetooth module (see
WLAN/Bluetooth combo card on page 43
)
e.
Keyboard (see
)
f.
Top cover (see
g.
System board (see
Remove the battery cable:
1.
Position the computer upright and open as far as possible.
2.
Remove the 2 Phillips PM2.5×4.0 screws that secure the battery cable to the computer (1).
3.
Remove the battery cable from the computer (2).
Reverse this procedure to install the battery cable.
Component replacement procedures 63
Summary of Contents for ProBook 470 G1
