Latch assembly
NOTE:
The latch kit is not spared.
Before removing the latch assembly, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Service door (see
).
b.
Hard drive (see
)
c.
Optical drive (see
d.
WLAN/Bluetooth module (see
WLAN/Bluetooth combo card on page 43
)
e.
Keyboard (see
)
f.
Top cover (see
g.
System board (see
NOTE:
The latch mechanisms include a small spring. Note the location of the spring.
Remove the latch assembly:
1.
Position the computer upside-down.
2.
Press on the tabs to disengage the latches from the lever (it clicks when disengaged).
3.
Push the lever toward the spring to gain access to the left side of the lever, and then pull the left
end of the lever upward (1).
Component replacement procedures 71
Summary of Contents for ProBook 470 G1
