3.
Lift the back of the board up, and then pull it into the computer to remove it (4).
To install the USB/audio board, reverse this procedure.
Speaker
To remove the speaker, use this procedure and illustration.
Table 5-7
Speaker description and part number
Description
Spare part number
Speaker
N07104-001
Before removing the speaker, follow these steps:
1.
Prepare the computer for disassembly (see
Preparation for disassembly on page 28
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the speaker:
1.
Disconnect the speaker cable from the system board (1).
2.
Remove display cable from the clip on the left side of the speaker (2).
3.
Remove the four Phillips M2.0 × 6.0 screws from the speaker (3).
Speaker
35