11-6
Using Authorized IP Managers
Defining Authorized Management Stations
Figure 11-2. Example of How To Add an Authorized Manager Entry (Continued)
Editing or Deleting an Authorized Manager Entry.
Go to the IP Manag-
ers List screen (figure 11-1), highlight the desired entry, and press
[E]
(for
Edit
)
or
[D]
(for
Delete
).
CLI: Viewing and Configuring Authorized IP Managers
Authorized IP Managers Commands Used in This Section
Listing the Switch’s Current Authorized IP Manager(s)
Use the
show ip authorized-managers
command to list IP stations authorized to
access the switch. For example:
5. Press
[Enter]
, then
[S]
(for
Save
) to configure the
IP Authorized Manager entry.
3. Use the default mask to allow access by one
management device, or edit the mask to allow
access by a block of management devices. See
“Building IP Masks” on page 11-9.
2. Enter an Authorized Manager IP address here.
4. Use the Space bar to select Manager or Operator
access.
Applies only to access through Telnet, SNMPv1,
and SNMPv2c. Refer to the Note on page 11-3.
Command
Page
show ip authorized-managers
below
ip authorized-managers
11-7
<ip-address>
11-8
<ip-mask-bits>
11-8
[access <operator | manager>]
