6-5
Interface Access, System Information, and Friendly Port Names
Interface Access: Console/Serial Link, Web, and Inbound Telnet
CLI: Modifying the Interface Access
Interface Access Commands Used in This Section
Listing the Current Console/Serial Link Configuration.
This com-
mand lists the current interface access parameter settings.
Syntax
:
show console
This example shows the switch’s default console/serial configuration.
Figure 6-2. Listing of Show Console Command
Reconfigure Inbound Telnet Access.
In the default configuration,
inbound Telnet access is enabled.
Syntax:
[no] telnet-server
To disable inbound Telnet access:
HPswitch(config)# no telnet-server
To re-enable inbound Telnet access:
HPswitch(config)# telnet-server
show console
below
[no] telnet-server
below
[no] web-management
page 6-6
console
page 6-6
Interface Access
Enable/Disable
Console Control
Options
Event Log Event
Types To List
Summary of Contents for ProCurve 4104GL
