6-7
Interface Access, System Information, and Friendly Port Names
Interface Access: Console/Serial Link, Web, and Inbound Telnet
■
VT100 operation
■
19,200 baud
■
No flow control
■
10-minute inactivity time
■
Critical log events
you would use the following command sequence:
Figure 6-3. Example of Executing the Console Command with Multiple Parameters
You can also execute a series of console commands and then save the
configuration and boot the switch. For example:
Figure 6-4. Example of Executing a Series of Console Commands
The switch implements the Event Log change immediately. The switch implements
the other console changes after executing
write memory
and
reload
.
Configure
the
individual
parameters.
Save the
changes.
Boot the
switch.
Summary of Contents for ProCurve 4104GL
