6-16
Interface Access, System Information, and Friendly Port Names
Using Friendly (Optional) Port Names
■
To retain friendly port names across reboots, you must save the current
running-configuration to the startup-config file after entering the friendly
port names. (In the CLI, use the
write memory
command.)
Configuring Friendly Port Names
Syntax:
interface [e] <
port-list
> name <
port-name-string
>
Assigns a port name to
port-list
.
no interface [e] <
port-list
> name
Deletes the port name from
port-list
.
Configuring a Single Port Name.
Suppose that you have connected port
A3 on the switch to Bill Smith’s workstation, and want to assign Bill’s name
and workstation IP address (10.25.101.73) as a port name for port A3:
Figure 6-9. Example of Configuring a Friendly Port Name
Summary of Contents for ProCurve 4104GL
