9-9
Optimizing Traffic Flow with Port Controls, Port Trunking, and Port-Based Priority
Viewing Port Status and Configuring Port Parameters
Configuring a Broadcast Limit on the Switch.
Executing this command
configures the broadcast limit for all ports on the switch.
Syntax:
broadcast-limit < 0 . . 99 >
For example, to configure a broadcast limit of 20% for all ports on the switch:
HPswitch(config)# broadcast-limit 20
To display the current broadcast limit setting, use one of the following com-
mands:
HPswitch# show config
Displays the startup-config file. The
broadcast limit setting appears here
if configured and saved to the
startup-config file.
HPswitch# show running-config
Displays the running-config file.
Web: Viewing Port Status and Configuring Port
Parameters
In the web browser interface:
1.
Click on the
Configuration
tab.
2.
Click on
[Port Configuration]
.
3.
Select the ports you want to modify and click on
[Modify Selected Ports]
.
4.
After you make the desired changes, click on
[Apply Settings]
.
Note that the web browser interface displays an existing port trunk group.
However, to configure a port trunk group, you must use the CLI or the menu
interface. For more on this topic, see “Port Trunking” on page 9-10.
Summary of Contents for ProCurve 4104GL
