12-7
Multimedia Traffic Control with IP Multicast (IGMP)
CLI: Configuring and Displaying IGMP
Viewing the Current IGMP Configuration.
This command lists the IGMP
configuration for all VLANs configured on the switch or for a specific VLAN.
Syntax:
show ip igmp config
IGMP configuration for all
VLANs on the switch
show ip igmp vlan
<vid>
config
IGMP configuration for a
specific VLAN on the switch,
including per-port data
(For IGMP operating status, see “Internet Group Management Protocol
(IGMP) Status” on page B-19.)
For example, suppose you have the following VLAN and IGMP configurations
on the switch:
You could use the CLI to display this data as follows:
Figure 12-1. Example Listing of IGMP Configuration for All VLANs in the Switch
The following version of the
show ip igmp
command includes the VLAN ID (
vid
)
designation, and combines the above data with the IGMP per-port configura-
tion:
VLAN ID VLAN Name
IGMP
Enabled
Forward with
High Priority
Querier
1
DEFAULT_VLAN
Yes
No
No
22
VLAN-2
Yes
Yes
Yes
33
VLAN-3
No
No
No
Summary of Contents for ProCurve 4104GL
