13-20
802.1w Rapid Spanning Tree Protocol (RSTP) and 802.1d Spanning Tree Protocol (STP)
802.1p Spanning-Tree Protocol (STP)
Figure 13-6. Enabling Spanning-Tree Operation
6.
If the remaining STP parameter settings are adequate for your network,
go to step 10.
7.
Use
[Tab]
or the arrow keys to select the next parameter you want to change,
then type in the new value or press the Space Bar to select a value. (If you
need information on STP parameters, press
[Enter]
to select the
Actions
line, then press
H
to get help.)
8.
Repeat step 7 for each additional parameter you want to change.
Note:
For information on the
Mode
parameter, see “STP Fast Mode” on
page 13-26.
9.
When you are finished editing parameters, press
[Enter]
to return to the
Actions
line.
10. Press
[S]
to save the currently displayed STP parameter settings. You will
then see the “Switch Configuration Menu” with an asterisk (
*
) at the
Spanning Tree Operation
line, indicating that you must reboot the switch
before the Protocol Version change (step 5) takes effect.
Use this field to enable spanning tree.
Read-Only Fields
Summary of Contents for ProCurve 4104GL
