13-33
802.1w Rapid Spanning Tree Protocol (RSTP) and 802.1d Spanning Tree Protocol (STP)
802.1p Spanning-Tree Protocol (STP)
3.
If the Protocol Version is set to RSTP (as shown in figure 13-14), do the
following:
a.
Press
[E]
(
Edit
) to move the cursor to the
Protocol Version
field.
b.
Press the Space bar once to change the
Protocol Version
field to STP.
c.
Press
[Enter]
to return to the command line.
d.
Press
[S
] (for
Save
) to save the change and exit from the Spanning Tree
Operation screen. you will then see a screen with the following:
Figure 13-15. Changing from RSTP to STP Requires a System Reboot
e.
Press
[0]
(zero) to return to the Main Menu, then
[6]
to reboot the
switch.
f.
After you reboot the switch, enter the menu command at the CLI to
return to the Main Menu, then select:
2. Switch Configuration . . .
4. Spanning Tree Operation
You will then see the Spanning Tree screen with
STP
(802.1d) selected
in the
Protocol Version
field (figure 13-16).
The asterisk indicates
that you must reboot the
switch to implement the
configuration change
from RSTP to STP.
Summary of Contents for ProCurve 4104GL
