13-35
802.1w Rapid Spanning Tree Protocol (RSTP) and 802.1d Spanning Tree Protocol (STP)
802.1p Spanning-Tree Protocol (STP)
Figure 13-17. Example of STP Enabled with Two Redundant Links Configured for
Fast-Uplink STP
5.
Press
[S]
(for
Save
) to save the configuration changes to flash (non-
volatile) memory.
To View Fast-Uplink STP Status.
Continuing from figures 13-16 and 13-17
in the preceding procedure, this task uses the same screen that you would use
to view STP status for other operating modes.
1.
From the Main Menu, select:
1. Status and Counters . . .
7. Spanning Tree Information
STP is enabled.
Port A1 and Trk1 are
now configured for
fast-uplink STP.
Summary of Contents for ProCurve 4104GL
