14-16
HP Procurve Stack Management
Configuring Stack Management
Figure 14-8. The Default Stack Configuration Screen
3.
Move the cursor to the Stack State field by pressing
[E]
(for
Edit
).
4.
Do one of the following:
•
To disable stacking on the Candidate, use the Space bar to select
the
Disabled
option, then go to step 5.
Note:
Using the menu interface to disable stacking on a Candidate
removes the Candidate from all stacking menus.
•
To insert the Candidate into a specific Commander’s stack:
i.
Use the space bar to select Member.
ii.
Press
[Tab]
once to display the
Commander MAC Address
parameter,
then enter the MAC address of the desired Commander.
•
To change
Auto Join
or
Transmission Interval
, use
[Tab]
to select the
desired parameter, and:
–
To change
Auto Join
, use the Space bar.
–
To change
Transmission Interval
, type in the new value in the range
of 1 to 300 seconds.
Note:
All switches in the stack must be set to the same transmis-
sion interval to help ensure proper stacking operation. HP recom-
mends that you leave this parameter set to the default 60 seconds.
Then go to step 5.
5.
press
[Enter]
to return the cursor to the
Actions
line.
Summary of Contents for ProCurve 4104GL
