8-16
Time Protocols
TimeP: Viewing, Selecting, and Configuring
Ti
m
e
Pr
ot
o
c
o
ls
Note:
This step replaces any previously configured TimeP server
IP address.
iii. Press
[>]
to move the cursor to the
Poll Interval
field, then go to step
6.
6.
In the
Poll Interval
field, enter the time in minutes that you want for a TimeP
Poll Interval.
Press
[Enter]
to return to the Actions line, then
[S]
(for
Save
) to enter the new
time protocol configuration in both the startup-config and running-config
files.
CLI: Viewing and Configuring TimeP
CLI Commands Described in this Section
This section describes how to use the CLI to view, enable, and configure TimeP
parameters.
Viewing the Current TimeP Configuration
This command lists both the time synchronization method (TimeP, SNTP, or
None) and the TimeP configuration, even if SNTP is not the selected time
protocol.
Syntax:
show timep
show timep
page 16
[no] timesync
page 17 ff., 19
ip timep
dhcp
page 17
manual
page 18
server <
ip-addr
>
page 18
interval
page 19
no ip timep
page 20
Summary of Contents for ProCurve 4108gl Bundle
