2-5
Using the Menu Interface
Starting and Ending a Menu Session
U
si
n
g t
h
e Me
nu
In
te
rfa
c
e
Figure 2-1. The Main Menu with Manager Privileges
For a description of Main Menu features, see “Main Menu Features” on page
2-7.
N o t e
To configure the switch to start with the menu interface instead of the CLI, go
to the Manager level prompt in the CLI, enter the
setup
command, and in the
resulting desplay, change the
Logon Default
parameter to
Menu
. For more infor-
mation, see the
Installation and Getting Started Guide
you received with the
switch.
How To End a Menu Session and Exit from the Console:
The method for ending a menu session and exiting from the console depends
on whether, during the session, you made any changes to the switch configu-
ration that require a switch reboot to activate. (Most changes via the menu
interface need only a
Save
, and do not require a switch reboot.) Configuration
changes needing a reboot are marked with an asterisk (*) next to the config-
ured item in the menu and also next to the
Switch Configuration
item in the
Main Menu.
Summary of Contents for ProCurve 4108gl Bundle
