13-33
HP Procurve Stack Management
HP Procurve Stack Management
H
P
Pr
oc
u
rv
e
S
tac
k
Ma
na
g
e
me
n
t
Using the CLI To View Stack Status
You can list the stack status for an individual switch and for other switches
that have been discovered in the same subnet.
Syntax:
show stack [candidates | view | all]
Viewing the Status of an Individual Switch.
The following example
illustrates how to use the CLI in a to display the stack status for that switch.
In this case, the switch is in the default stacking configuration.
Syntax:
show stack
Figure 13-22. Example of Using the Show Stack Command To List the Stacking Configuration for an
Individual Switch
Viewing the Status of Candidates the Commander Has Detected.
This example illustrates how to list stack candidates the Commander has
discovered in the ip subnet (broadcast domain).
Syntax:
show stack candidates
Figure 13-23. Example of Using the Show Stack Candidates Command To List
Candidates
Summary of Contents for ProCurve 4108gl Bundle
