13-36
HP Procurve Stack Management
HP Procurve Stack Management
HP
P
roc
urve
S
tack
M
ana
gem
e
n
t
Figure 13-26. Example of the Commander’s Show Stack Screen with Only the
Commander Discovered
Using a Member’s CLI to Convert the Member to the Commander of a
New Stack.
This procedure requires that you first remove the Member from
its current stack, then create the new stack. If you do not know the MAC
address for the Commander of the current stack, use
show stack
to list it.
Syntax:
no stack
stack commander
<stack name>
Suppose, for example, that a
HP4108
named “Bering Sea” is a Member of a stack
named “Big_Waters”. To use the switch’s CLI to convert it from a stack Member
to the Commander of a new stack named “Lakes”, you would use the following
commands:
The
stack commander
command
configures the Commander and names
the stack.
The Commander appears in the stack as Switch
Number (SN) 0.
Summary of Contents for ProCurve 4108gl Bundle
