Installing a 3.5-inch device
1.
Prepare the computer for disassembly (
Preparation for disassembly on page 85
).
2.
Remove the access panel (
Access panel on page 86
).
3.
Remove the front bezel (
Front bezel on page 87
). If you are installing a drive in a bay covered by
a bezel blank, remove the bezel blank. See
Bezel blanks on page 90
for more information.
4.
Install 6-32 guide screws in the holes on each side of the drive.
NOTE:
HP has supplied four extra 6-32 guide screws on top of the drive cage. Refer to
Drives
on page 99
for an illustration of the extra guide screws location.
When replacing a drive, transfer the four 6-32 guide screws from the old drive to the new one.
5.
Rotate the drive cage to its upright position.
Drives
103
