Bezel blanks
Description
Spare part number
Optical drive bezel blank
732770-001
On some models, there are bezel blanks covering the 3.5-inch and 5.25-inch drive bays that need to
be removed before installing a drive. To remove a bezel blank:
1.
Remove the access panel (
Access panel on page 38
)
2.
Remove the front bezel (
Front bezel on page 40
)
3.
Remove the bezel blank for the appropriate drive:
{
To remove a 5.25-inch bezel blank, press inward on the retaining tabs that hold the bezel
blank in place (1) then pull the bezel blank from the front bezel (2).
NOTE:
After removing the 5.25-inch drive bezel blank and installing a drive, you can
install an optional bezel trim piece (available from HP) that surrounds the front of the drive.
Bezel blanks
41
