7.
Connect the opposite end of the data cable to one of the light blue SATA connectors on the system
board.
NOTE:
Refer to
System board connections on page 50
for an illustration of the system board
drive connectors.
8.
Replace the front bezel.
NOTE:
An optional bezel trim piece that surrounds the front of the 5.25-inch drive is available
from HP. Install the bezel trim piece in the front bezel before replacing the front bezel.
Removing a 3.5-inch device
CAUTION:
All removable media should be taken out of a drive before removing the drive from the
computer.
1.
Prepare the computer for disassembly (
Preparation for disassembly on page 37
)
2.
Remove the access panel (
Access panel on page 38
)
3.
Remove the front bezel (
Front bezel on page 40
)
4.
Disconnect the drive cables from the rear of the drive, or, if you are removing a media card
reader, disconnect the USB cable from the system board as indicated in the following illustration.
56
Chapter 5 Removal and replacement procedures: Tower (TWR)
