Hardware options installation 38
3.
Remove the access panel (on page
15
).
4.
If installed, disconnect the hard drive power and data cables from the system board.
5.
Remove the air baffle (on page
15
).
6.
Configure the air baffle ("
Configuring the air baffle for DIMM installation
" on page
36
).
7.
Open the DIMM slot latches.
8.
Install the DIMM.
9.
Install the air baffle (on page
15
).
10.
If removed, connect the hard drive power and data cables to the system board ("
Hard drive
connector identification
" on page
10
).
11.
Install the access panel (on page
15
).
If you are installing DIMMs in mirrored or lock-step configuration, configure this mode in RBSU ("
HP ROM-
Based Setup Utility
" on page
60
).
Mezzanine card option
Optional mezzanine cards are classified as Type I mezzanine cards and Type II mezzanine cards. The
card type determines where it can be installed in the server blade.
•
Install Type I mezzanine cards on either mezzanine 1 connector or mezzanine 2 connector.
•
Install Type II mezzanine cards only on mezzanine 2 connector.
Optional mezzanine cards enable network connectivity or provide Fibre Channel support. For mezzanine
card locations, see the system board components (on page
9
).
For mezzanine card mapping, see the HP ProLiant BL280c G6 Server Blade Installation Instructions or see
"Interconnect bay numbering and device mapping (on page
18
)."
To install the component:
1.
Power down the server blade (on page
13
).
2.
Remove the server blade (on page
14
).
3.
Remove the access panel (on page
15
).
