Removal and Replacement Procedures
HP ProLiant DL145 Generation 2 Server Maintenance and Service Guide
2-35
Figure 2-40: Removing a memory module
6.
Place the memory module on a static-dissipating work surface or inside an anti-static bag.
To install a memory module:
1.
Perform steps 1 through 3 of the “To remove a memory module” section.
2.
Locate an empty DIMM slot on the system board.
3.
If necessary, open the holding clips of the selected DIMM slot.
4.
Remove the memory module from its protective packaging, handling it by the edges.
5.
Install the memory module:
a.
Orient the module so that the notch on its bottom edge aligns with the keyed surface
of the DIMM slot, and then press it fully into the slot.
The DIMM slots are structured to ensure proper installation. If you insert a memory
module but it does not fit easily into the slot, you may have inserted it incorrectly.
Reverse the orientation of the module and insert it again.
b.
Firmly press the holding clips inward to secure the memory module in place.
If the holding clips do not close, the module is not inserted correctly.
Figure 2-40: Installing a memory module
6.
Perform the post-installation procedures described on page 2-6.
All manuals and user guides at all-guides.com
