a.
Extend the server from the rack (
Extend the server from the rack
on page 24).
b.
Remove the server from the rack (
Remove the server from the rack
6.
7.
Install the HPE Smart Array P816i-a controller.
8.
Connect the cables.
The following illustration shows the 8+2 SFF backplane configuration connected to the controller.
Additional cabling options are available. For more information, see the HPE DL360 Gen10 Server cabling
matrix on the Hewlett Packard Enterprise website (
http://www.hpe.com/info/CablingMatrixGen10
).
9.
Install the access panel (
on page 25).
10.
Install the server in the rack.
11.
Connect each power cord to the server.
12.
Connect each power cord to the power source.
13.
Power up the server (
on page 24).
88
Hardware options installation