Hardware options installation 55
•
In multiprocessor configurations, each processor must have a valid Lockstep memory mode
configuration.
•
In multiprocessor configurations, each processor may have a different valid Lockstep memory mode
configuration.
Population order
For Lockstep memory mode configurations with a single processor or multiple processors, populate the DIMM
slots in the following order:
•
First: B and C
•
Last: E and F
Do not populate the DIMM slots A and D.
After installing the DIMMs, to configure memory protection mode, use RBSU ("
HP ROM-Based Setup Utility
"
on page
83
).
Installing a DIMM
1.
Power down the server (on page
17
).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page
17
).
o
Remove the server from the rack (on page
18
).
4.
Remove the access panel (on page
19
).
5.
Open the DIMM slot latches.
6.
Install the DIMM.
7.
Install the access panel (on page
20
).
8.
Install the server into the rack ("
Installing the server into the rack
" on page
27
).
Summary of Contents for ProLiant DL360e Gen8
