Removal and replacement procedures 60
o
Extend the server from the rack (on page
30
).
o
Remove the server from the rack (on page
31
).
5.
Remove the access panel ("
Access panel
" on page
35
).
6.
Remove the fans ("
Hot-plug fan blank and module
" on page
39
).
7.
Remove the PCI riser cage ("
PCI riser cage
" on page
50
).
8.
Disconnect all cables connected to the system board.
9.
Remove all DIMMs ("
DIMMs
" on page
43
).
10.
If installed, remove the heatsink blank ("
Heatsink blank
" on page
43
).
11.
Remove the heatsink:
a.
Loosen one pair of diagonally opposite screws halfway, and then loosen the other pair of screws.
b.
Completely loosen all screws in the same sequence.
c.
Remove the heatsink from the processor backplate.
