Hardware options installation 52
Item Description
Definition
4
Voltage rating
L = Low voltage (1.35v)
U = Ultra low voltage (1.25v)
Blank or omitted = Standard
5
Memory speed
12800 = 1600-MT/s
10600 = 1333-MT/s
8500 = 1066-MT/s
6
DIMM type
R = RDIMM (registered)
E = UDIMM (unbuffered with ECC)
L = LRDIMM (load reduced)
H = HDIMM (HyperCloud)
For the latest supported memory information, see the QuickSpecs on the HP website
(
http://h18000.www1.hp.com/products/quickspecs/ProductBulletin.html
). At the website, choose the
geographic region, and then locate the product by name or product category.
Memory configurations
To optimize server availability, the server supports the following AMP modes:
•
Advanced ECC—provides up to 4-bit error correction and enhanced performance over Lockstep mode.
This mode is the default option for this server.
•
Online spare memory—provides protection against failing or degraded DIMMs. Certain memory is
reserved as spare, and automatic failover to spare memory occurs when the system detects a DIMM that
is degrading. This allows DIMMs that have a higher probability of receiving an uncorrectable memory
error (which would result in system downtime) to be removed from operation.
Advanced Memory Protection options are configured in RBSU. If the requested AMP mode is not supported
by the installed DIMM configuration, the server boots in Advanced ECC mode. For more information, see
"HP ROM-Based Setup Utility (on page
104
)."
The server also can operate in independent channel mode or combined channel mode (lockstep). When
running in lockstep mode, you gain reliability in one of two ways:
•
If running with UDIMMs (built with x8 DRAM devices), the system can survive a complete DRAM failure
(SDDC). In independent channel mode, this failure would be an uncorrectable error.
•
If running with RDIMM (built with x4 DRAM devices), the system can survive the complete failure of two
DRAM devices (DDDC). Running in independent mode, the server can only survive the complete failure
of a single DRAM device (SDDC).
Maximum capacity
DIMM type
DIMM rank
One processor
Two processors
RDIMM
Single-rank
96 GB
192 GB
RDIMM
Dual-rank
192 GB
384 GB
LRDIMM
Quad-rank
384 GB
768 GB
UDIMM
Single-rank
32 GB
64 GB
UDIMM
Dual-rank
64 GB
128 GB
HDIMM
Dual-rank
192 GB
384 GB
For the latest memory configuration information, see the QuickSpecs on the HP website
(
http://www.hp.com
).
Summary of Contents for ProLiant DL380p Gen8
