Removal and replacement procedures 58
5.
Remove the expansion slot cover.
Figure 3-36
Removing the expansion slot cover
6.
Position the expansion card over the expansion slot connector and push down (Figure 3-37, 1).
CAUTION:
When installing an expansion card, hold the card just above the expansion slot on the
system board, and then move the card toward the rear of the chassis so that the bracket on the card
is aligned with the open slot on the rear of the chassis.
7.
Press down the card holder until the latches snap into position in the rear panel, securing the
expansion card into the slot (Figure 3-37, 2).
Figure 3-37
Installing an expansion card
8.
Connect any interior cables associated with the installed expansion card.
9.
Replace the side access cover.
10.
Reconnect the power cord(s).
End of procedure.
All manuals and user guides at all-guides.com
Summary of Contents for ProLiant ML150 G6
Page 12: ...Customer self repair 12 All manuals and user guides at all guides com ...
Page 13: ...Customer self repair 13 All manuals and user guides at all guides com ...
Page 14: ...Customer self repair 14 All manuals and user guides at all guides com ...
Page 15: ...Customer self repair 15 All manuals and user guides at all guides com ...
