Removal and Replacement Procedures
CD-ROM Drive
To remove the CD-ROM drive:
1. Prepare the server for a non-hot-plug procedure. Refer to “Preparing the Server for
Non-Hot-Plug Procedures” in this chapter.
2. Remove the front bezel door (tower model only), and lay the server on its side with the
access panel facing upward. Refer to “Removing the Front Bezel Door (Tower Model
Only)” in this chapter.
3. Remove the access panel. Refer to “Removing the Access Panel” in this chapter.
4. Remove the hot-plug processor fan. Refer to “Hot-Plug Fans (Processor and I/O)” in this
chapter.
5. Remove the fan basket. Refer to “Fan Basket” in this chapter.
6. Remove the processor fan bracket. Refer to “Processor Fan Bracket” in this chapter.
7. Open the system tray. Refer to “Opening the System Tray” in this chapter.
8. Disconnect the power and signal cables from the CD-ROM drive. Refer to “Diskette and
CD-ROM Drive Cables” in this chapter.
9. Loosen the thumbscrew located near the bottom of the fan basket to release the metal
locking bracket
(1)
.
10. Slide the metal locking bracket outward
(2)
.
11. Push the CD-ROM drive out of the front of the chassis
(3)
.
Figure 2-48: Removing the CD-ROM drive
Reverse steps 1 through 11 to replace the CD-ROM drive.
HP ProLiant ML570 Generation 2 Server Maintenance and Service Guide
2-57
Summary of Contents for ProLiant ML570 Generation 2
Page 6: ......
