Error messages 108
Description
: More logical drives were created than are supported on this controller, causing lost logical
drive volumes.
Action
: Identify the drives containing lost volumes, and then move them to another controller so the lost
volumes can be recreated.
CAUTION:
Removing a drive that contains valid volume data causes all valid data to be lost.
System Board is Unable to Identify which Slots the Controllers are in
Description
: The slot indicator on the system board is not working correctly. Firmware recognizes both
controllers as being installed in the same slot.
Action
:
1.
Be sure both controllers are fully seated in their slots.
If the problem persists, this might indicate a controller problem or a system board problem.
CAUTION:
Only authorized technicians trained by HP should attempt to remove the system
board. If you believe the system board requires replacement, contact HP Technical Support
("
Contacting HP
" on page
173
) before proceeding.
2.
Remove one of the controllers in the configuration and see if the remaining controller generates a
POST message.
3.
Move the remaining controller to the other slot to see if it still generates a POST message.
4.
Repeat these steps with the other controller.
If both controllers give POST messages in one slot but not the other, it is a system board problem. If one of
the controllers gives POST messages and the other controller does not, replace the controller that is giving
the POST messages. Contact an authorized service provider for any warranty replacements.
The Redundant Controllers Installed are not the Same Model...
...SOLUTION: Power down the system and verify that the redundant controllers are different models. If they are
different models, replace the other controller with the same model as this one.
Description
: ADU detected two different controller models installed in a redundant controller configuration.
This is not supported and one or both controllers may not be operating properly.
Action
: Use the same controller models for redundant controller configurations.
This Controller Can See the Drives but the Other Controller Can't
Description
: The other controller in the redundant controller configuration cannot recognize the drives, but
this controller can.
Action
: Resolve any other errors and then rerun ADU ("
Array diagnostic software
" on page
76
).
This Controller Can't See the Drives but the Other Controller Can
Description
: The other controller in the redundant controller configuration can recognize the drives, but
this controller cannot.
Action
: Resolve any other errors and then rerun ADU ("
Array diagnostic software
" on page
76
).
