NOTE:
This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are
ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for information on CTO
product offerings and requirements.
NOTE:
Configure-to-order server blades must start with a CTO Blade Server.
NOTE:
FIO indicates that this option is only available as a factory installable option.
NOTE:
All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of initial hard drives
ordered with the server.
Step 1: Base Server Blade Configuration (Select a configurable Blade)
HP Models
HP ProLiant WS460c Gen8 E5-v2 Configure-to-order Workstation
739347-B21
NOTE:
Single-width, half-height bade with two mezzanine card slots available.
NOTE:
HP Smart Array P220i Controller FIO Kit (690164-B21) must be added separately
as part of the Server Blade Configuration Process.
Configurable Model ships with:
One (1) FlexibleLOM connector providing a choice for one (1) of the supported 10Gb
FlexibleLOMs (see Step 2)
Two (2) HP small form factor hot-plug SAS/SATA/SSD hard drive bays
Two (2) x16 PCIe I/O expansion slots (one Type A, one Type A/B)
One (1) integrated USB connector and one (1) MicroSDHC connector
One (1) TPM connector
HP iLO Management Engine (standard)
HP ProLiant WS460c Gen8 Configure-to-order Workstation
678276-B21
NOTE:
Single-width, half-height bade with two mezzanine card slots available.
NOTE:
The HP Smart Array P220i Controller FIO Kit (690164-B21) comes included with
the HP ProLiant WS460c Gen8 10Gb FlexibleLOM Configure-to-order Blade Server
(678276-B21).
Configurable Model ships with:
One (1) FlexibleLOM connector providing a choice for one (1) of the supported 10Gb
FlexibleLOMs (see Step 2)
One (1) HP Smart Array P220i Controller with 512MB FBWC and RAID 0 and 1 support
Two (2) HP small form factor hot-plug SAS/SATA/SSD hard drive bays
Two (2) x16 PCIe I/O expansion slots (one Type A, one Type A/B)
One (1) integrated USB connector and one (1) MicroSDHC connector
One (1) TPM connector
HP iLO Management Engine (standard)
HP WS460c Gen8 E5-v2 Graphics Expansion Configure-to-order Blade
739348-B21
NOTE:
Double-width half-height blade with two, full-length, PCIe x16 slots. No
mezzanine card slots on base blade are currently available.
NOTE:
HP Smart Array P220i Controller FIO Kit (690164-B21) must be added separately
as part of the Server Blade Configuration Process.
NOTE:
Base unit comes only with Slot1 of the expansion blade enabled. To enable
Slot2, optional Slot2 Enablement FIO Kit (PN 721120-B21) is required. This kit is
available at time of initial purchase only.
Configurable Model ships with:
One (1) FlexibleLOM connector providing a choice for one (1) of the supported 10Gb
FlexibleLOMs (see Step 2)
Two (2) HP small form factor hot-plug SAS/SATA/SSD hard drive bays
QuickSpecs
HP ProLiant WS460c Gen8 Workstation Blade
Configuration Information - Factory Integrated Models
DA - 14409 North America — Version 16 — December 13, 2013
Page 23