Operations 14
Remove the processor air baffle
1.
Power down the server (on page
12
).
2.
Disconnect all peripheral cables from the server.
3.
Remove the server (on page
13
).
4.
Remove the processor air baffle.
Remove the PCI riser board assembly
1.
Power down the server (on page
12
).
2.
Disconnect all peripheral cables from the server.
3.
Remove the server (on page
13
).
4.
Place the server on a flat, level work surface.
5.
Disconnect all cables connected to existing expansion boards.
IMPORTANT:
Both T-10 and T-15 screws are required for this procedure. When replacing the
component, be sure to install the screws in the proper location. Failure to do so will cause the
server to not install properly into the chassis.
Summary of Contents for ProLiant XL220a Gen8 v2
Page 65: ...Support and other resources 65 ...
Page 66: ...Support and other resources 66 ...
Page 74: ...Index 74 W website HP 59 ...
