1.
Remove the two screws securing the UPS option slot cover plate
and remove.
2.
Install the UPS Network Module along the alignment channels in
the option slot.
3.
Secure the UPS Network Module using the two screws you
removed in step 1.
4.
If the UPS is powered up, you can be sure that the UPS Network
Module is seated properly and communicating with the UPS by
verifying that the UPS Data LED illuminates solid green, and then
flashes regularly after 2 minutes.
Connecting the UPS Network
Module
The UPS Network Module card is provided to manage the attached
servers. RJ 45 network patch panel cables are required to use this card.
The RJ 45 network patch panel cables are not included.
